A. With motorcycle properly supported on jack, remove the stock shocks.
B. Apply blue threadlocker to the hardware and install your REVO shocks FIGURE A. If installing REVO-A install with adjuster knob facing the rear of the motorcycle.
C. Torque hardware to OE specifications.
Before purchasing or attempting to install shocks that are different than the OEM length, confirm that the wheel travel can be altered without causing clearance issues, such as swing-arm/axle to exhaust contact as well as chain/belt guard and tire clearance.
Once shocks are installed with the proper hardware FIGURE A, make sure you can rotate them freely in both directions FIGURE B.
IF SHOCKS DO NOT ROTATE FREELY, CHECK THAT THE HARDWARE IS INSTALLED CORRECTLY.
|Proper Sag Measurement